Installation Guide
Every wrap we make installs the same way. No tools, no gunsmithing, nothing permanent. Most people finish in about four minutes.
Clean the application area
Wipe every surface that will receive adhesive with an alcohol wipe, and let it dry completely.
This is the step people skip and it's the one that decides whether the wrap is still on in a year. Oil, solvent and skin oil all stop the adhesive bonding. If you do nothing else carefully, do this.
Remove the 3M liner
Peel the adhesive liner off the back of the wrap — either fully, or partially if you'd rather work in sections on a larger panel.
The liner is cut with relief slits so you don't have to pick at a corner and risk creasing the wrap.
Line it up — take your time here
Start at any end and lay the wrap down lightly, working across the rest of the area.
You have about 20 minutes. The material stretches slightly and can be lifted and reapplied as many times as you need in that window to get the best fit. Use it. Lift it, shift it, put it back.
Most wraps have a natural reference point — a magazine release cutout, a bevel that follows the frame. Register that first and work outward.
Make sure you're happy with the fit before moving on. After the next step it's much harder to adjust.
Press it down
Once everything is wrapped and positioned, apply firm pressure across the whole area to activate the adhesive. Work from the centre outward and go around a second time pressing the edges specifically — edges are where lifting starts.
Optional: a pass with a blow dryer strengthens the bond further. Confirm the firearm is unloaded first, keep the dryer moving, and stop when the wrap is warm rather than hot. This is a one-way door: heat makes the wrap significantly harder to remove or reposition later. Skip it unless you're certain of the fit.
Finish the edges
If any threads are loose at the edges, singe them with a lighter or torch. Pass the flame across quickly — you're melting thread ends, not burning fabric. A fraction of a second is enough.
Give it 20 minutes
That's it — the wrap is on. Leave it 20 minutes before you holster or carry, and the adhesive is fully set.
Which is the neat thing about the 20-minute number: it's the same window either way. For the first 20 minutes the wrap is still adjustable. After 20 minutes it's done and ready to go to work.
Taking a wrap off
Wraps come off clean. Peel from a corner and pull steadily — the adhesive almost always comes away with the wrap rather than staying on the firearm.
If a little adhesive does stay behind, roll it up with your thumb and it balls off. For anything in a tight corner or a slot you can't get a finger into, Goo Gone will take care of it. If you used a blow dryer during installation, expect removal to take a bit more work.
Common questions
No. Our wraps use 3M Low Surface Energy adhesive, which grips mechanically rather than bonding chemically to polymer. It comes off clean. On aftermarket coatings that are already chipping or poorly applied, any adhesive can lift the finish — that's a pre-existing coating problem, but worth knowing before you start.
Within the first 20 minutes, lift it and reapply as many times as you need. After you've pressed it down firmly — and especially after applying heat — it's much harder to adjust.
Twenty minutes. Same window in which you can still reposition it. Once that's passed the adhesive is set and it's ready to carry.
Yes. Peel it off and it comes away clean — the adhesive usually lifts with the wrap. Any residue balls up under your thumb, and Goo Gone handles anything in a tight spot.
Cordura 1000D adds roughly half a millimetre. Most kydex holsters absorb that. A very tight custom holster with minimal retention adjustment may need a quarter-turn on the screws.
A wrap carried daily against the body starts showing wear somewhere between twelve and twenty-four months. It's fabric — that's also why it feels the way it does.
Email [email protected] and we'll help you sort it out.
